Now that the Denis Welch tappets have finally arrived and been installed the pushrods and rocker assembly are next.  The four cylinder short block and head were <div id="yMail_cursorElementTracker_1591108538998">machined by my late restorer friend.  I have no idea what was cut off the two mating surfaces of the block and head.  Do I need to shim the rocker pedestals? If so, how do I figure how much they should be shimmed?</div><div id="yMail_cursorElementTracker_1591108550356">Mike MacLean<br><br><div id="ymail_android_signature"><a id="ymail_android_signature_link" href="https://go.onelink.me/107872968?pid=InProduct&c=Global_Internal_YGrowth_AndroidEmailSig__AndroidUsers&af_wl=ym&af_sub1=Internal&af_sub2=Global_YGrowth&af_sub3=EmailSignature">Sent from AT&T Yahoo Mail on Android</a></div></div>