<div dir="auto">Listers,<div dir="auto"><br></div><div dir="auto">I am attempting to replace the shattered glass in the driver's side door on my BJ8.  The rubber strip that goes into the window channel has been placed in the channel.  </div><div dir="auto"><br></div><div dir="auto">I cannot get the glass to slide into the rubber and channel.  I wet both the rubber and the glass with a mixture of water and dish soap but the glass will not go into the rubber/channel.  The glass rattles around in the channel without the rubber so I know the channel is the right size.  I think the rubber is intended to provide a tight fit into the channel.  However, with the rubber in place and with soap and water, the glass simply will not go in.</div><div dir="auto"><br></div><div dir="auto">Any ideas on how to get this fitted properly?  I am afraid to use a dead blow  hammer on the channel.</div><div dir="auto"><br></div><div dir="auto">Thanks,</div><div dir="auto"><br></div><div dir="auto">Fred</div><div dir="auto">66BJ8</div><div dir="auto"><br></div></div>