[Healeys] Heater control tap

[Michael Salter]

But, as I recall they are the only place on a Healey that has a 12/32 thread.


________________________________
From: Healeys <healeys-bounces at autox.team.net> on behalf of JSARCH <jmsdarch at sbcglobal.net>
Sent: Tuesday, 18 August 2026 14:43:03
To: 'Bob Spidell' <bspidell at comcast.net>; healeys at autox.team.net <healeys at autox.team.net>
Subject: Re: [Healeys] Heater control tap


It is not hard to fabricate a correctly shaped handle out of a piece of bronze stock.



John,

’62 BT7



From: Healeys <healeys-bounces at autox.team.net> On Behalf Of Bob Spidell via Healeys
Sent: Tuesday, August 18, 2026 9:04 AM
To: healeys at autox.team.net
Subject: Re: [Healeys] Heater control tap



Years ago, I bought a couple tap handles--the part most likely to break--from Bob Yule at Autofarm. He was the only vendor I could find that supplied that part, so check with him.

Note: The valves can often be 'rebuilt' by  polishing the conical seat with some fine sandpaper.

Bob

On 8/17/2026 8:01 AM, Fred Wescoe wrote:

Listers,



I am looking for a heater control tap for my 66 BJ8.  This is the water shutoff valve from the block that controls the flow of water to the heater, Moss part # 835-620.



Does anyone have one they would sell or does anyone know a source other than Moss?



Thanks,



Fred




-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20260818/a74951d7/attachment.htm>