[Healeys] Head bolt torque
Fred Wescoe
fredwescoe at gmail.com
Fri Apr 21 08:44:13 MDT 2023
Thanks to all who replied to my question about head bolt torque. I was
having an old brain failure and doing the math the wrong way. I have now
recognized my error and have gone the correct way.
Thanks,
Fred
On Thu, Apr 20, 2023 at 9:32 PM Ricchardd Mayor <boyracer466 at gmail.com>
wrote:
> The head studs do not go into any water jacket. Do not use any sealant.
> In spite of what any manual says, you should only put the studs in finger
> tight.
>
>
> Richard Mayor
> boyracer466 at gmail.com
>
>
> On Apr 20, 2023, at 5:55 PM, Hank Leach via Healeys <
> healeys at autox.team.net> wrote:
>
> When torquing the nuts it's a good practice to do them in 1/3 increments
> so if 75 is your target-do the first tightening around 25-30 then about 60
> and finally 75 following the diagram in the workshop manual for all 16 nuts
> recommended tightening order. Haynes also recommends 900 inch lbs as the
> target.Use Locktiite white as the sealant for all studs-especially the ones
> which go into the water jacket! Hank
>
> -----------------------------------------
> From: "Fred Wescoe via Healeys"
> To: "healeys"
> Cc:
> Sent: Thursday April 20 2023 3:37:03PM
> Subject: [Healeys] Head bolt torque
>
> Listers,
>
> I am assembling my rebuilt 66 BJ8 cylinder head.
>
> What torque reading should I take the nuts to? The manual says 900 inch
> pounds which is 56.25 foot pounds. That doesn't seem right. I have been
> told 70 - 75 foot pounds. I have also been told 85 foot pounds.
>
> Everyone says to reach final torque in 3 steps, increasing by 15 pounds
> each step.
>
> What is correct?
>
> I have also been told to seal each head bolt into the block. If so, what
> sealant should I use?
>
> Fred
>
> 66BJ8
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive/healeys
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/boyracer466@gmail.com
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20230421/17145268/attachment.htm>
More information about the Healeys
mailing list