[Healeys] BJ8 seat runners

[Bob Spidell]

I did it with regular bolts; welded them in and ground the heads down. 
One of the trickier aspects is removing the limiting pins on each end 
(they also retain the ball bearings). I don't recall how I got them out, 
but I remember it was a bit of a hassle. I replaced them with roll pins. 
I also lost a ball bearing or two; easy enough to replace (5/16" IIRC).


On 12/13/2022 8:03 PM, Alan Seigrist via Healeys wrote:
> David -
>
> You can tack weld new T-bolts in there without too much effort.  They 
> are pretty basic.
>
> Cheers,
>
> Alan
>
> On Wed, Dec 14, 2022 at 10:28 AM David Lodge via Healeys 
> <healeys at autox.team.net> wrote:
>
>     Has anyone had a pop at restoring these, or do I have to act the
>     lone pioneer................again. (Not that I really mind - which
>     is a good thing! - but any shortcuts appreciated, etc)
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20221214/6b3ed4ee/attachment.htm>