[Healeys] BN2 Fan Belt
michael.oritt at gmail.com
Sun Oct 17 09:04:25 MDT 2021
After you get the proper fan belt consider installing one of these:
The initial installation of the unit is a bit intense but once you have it
in place tensioning the belt is a piece of cake.
On Sun, Oct 17, 2021 at 10:06 AM Bob Spidell <bspidell at comcast.net> wrote:
> I'm going to return it, with '8x10 colored glossy photographs.'
> On 10/17/2021 6:43 AM, warthodson at aol.com wrote:
> The way the vendors find out about an issue is if the customer tells
> them. You should forward your message to Moss.
> Gary Hodson
> -----Original Message-----
> From: Bob Spidell <bspidell at comcast.net> <bspidell at comcast.net>
> To: Healeys <healeys at autox.team.net> <healeys at autox.team.net>
> Sent: Sat, Oct 16, 2021 7:52 pm
> Subject: [Healeys] BN2 Fan Belt
> I finally got around to fixing my loose water pump pulley and installing a
> new fan belt. I ordered a 'cogged' belt from Moss--part# 021-966--thinking
> it might work better than the original slab of rubber. I noticed before
> installing that it was narrower than the original type that I'd had, which
> had rotted, but it looked like it would work. Once I started tensioning it
> however, it was clear it *might *work, but sat too low in the pulleys,
> and was essentially riding on the bottom of the pulley grooves instead of
> on the sides (and the angle of the sides of the belt was incorrect). Anyone
> else tried one of these?
> I'm shocked, SHOCKED I TELL YA', that a vendor would sell something that
> could possibly work, but isn't truly correct.
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/pipermail/healeys
> Healeys at autox.team.net
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Healeys