[Healeys] Springs holding the shift stick in the tower housing

rfbegani at gmail.com rfbegani at gmail.com
Mon Nov 15 07:08:39 MST 2021

Thanks to those who helped me, I confirmed that the screws were not worn and
I needed a new nylon bearing.  It snaped around the ball so I applied
lithium grease to the end and the sides of the stick and housing installed
the screws.  When for a ride noting that the shifting was nice and smooth
like it should be.  I did all this without removing the tunnel which makes
it difficult to install the springs and circle clip retainer into the tower.
Any suggestions?




Bob Begani

BJ8 67

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20211115/80ae3e3f/attachment.htm>

More information about the Healeys mailing list