[Healeys] Dimensions
Bob Haskell
rchaskell at earthlink.net
Fri May 14 13:34:26 MDT 2021
Simon,
The dimension from the front face of the front outrigger to the back
face of the rear outrigger is 39 7/16" or 100.17 cm.
Cheers,
Bob Haskell
Austin Healey 3000 BN7/BT7 registrar
On 5/14/21 10:54 AM, Simon Lachlan via Healeys wrote:
>
> Still looking, albeit in a fairly desultory fashion, for a lift. I saw
> the recent correspondence regarding the QuickJack system and that the
> opinions were fairly positive.
>
> Assuming that you have a 3000, where do you put the 4 jacking points
> or can you go straight on below the chassis?
>
> I’m told that one should not lift by the sills, which makes sense and
> that a “good” point is at the junction of the outriggers to the chassis.
>
> The QuickJack is fairly pricey over here, for what it is, and I’m
> looking at other systems. I’d get a 2-poster like a shot but am have
> very little overhead clearance. So, scissors are a good option. With
> that in mind, can anyone tell me what the distance is between A & B
> per the attached. It is supposed to show the distance between the
> mid-point of the fore and aft outriggers.
>
> If only the chassis was not so narrow!
>
> Simon
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/rchaskell@earthlink.net
>
More information about the Healeys
mailing list