[Healeys] Bellcrank Position

Alan Seigrist healey.nut at gmail.com
Tue Jun 29 02:44:54 MDT 2021


Hi Michael -

Okay sorry, I just realised your bellcrank lever is the bigger one, sorry
for the confusion.

Your Bellcrank is swapped around.

The lower rod should be connected to the short side of the bellcrank to the
rear of the pivot pin, and the rod to the exhaust manifold should be up
high above the footwell with the ball joint on the outside of the bellcrank
lever (opposite of where you have it now).  Since the tall part of the
bellcrank will be above the footwell, it will not interfere with the
footwell.

Best,

Alan

On Tue, Jun 29, 2021 at 2:05 PM Michael MacLean via Healeys <
healeys at autox.team.net> wrote:

> Can you 100 guys tell me if the bent arms of the throttle bellcrank on the
> driver's footwell are oriented towards the footwell, or the open engine
> bay?  There seems to be a lot of binding and interference with the pushrods
> in the position in the picture.  Thought I saw it this way in other
> photographs on the internet.
> Mike MacLean
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/healey.nut@gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20210629/9fb414bb/attachment.htm>


More information about the Healeys mailing list