[Healeys] pilot bush
Michael MacLean
springer.mike51 at gmail.com
Fri Jun 11 21:52:55 MDT 2021
I have used a carbide ball bit in the past to cut a groove down to the
bore. It comes out easily after that. I was just hoping there was an
easier way. Besides, I don't have a carbide ball cutter bit at this time.
Mike MacLean
On Fri, Jun 11, 2021, 8:45 PM healeymanjim via Healeys <
healeys at autox.team.net> wrote:
> just replaced one a few weeks ago. the grease trick and pullers, etc. did
> not work. had to resort to hacksaw blade and cold
> chisel, taking it out in pieces.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/springer.mike51@gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20210611/285ea7c2/attachment.htm>
More information about the Healeys
mailing list