[Healeys] Running problem

Thu May 28 19:31:01 MDT 2020

Brian,

Another possibility is gunk and debris was sucked up my the in-tank filter
when you ran out of gas and it is fowled. There is a filter at the end of
the pickup tube inside the tank. The fuel lines are different on a BJ8 than
my Mk1 BT7 but a suggestion is to remove the line between the fuel pump and
the tank and flush it out and pressure test. Then blow compressed air back
into the tank through the fitting for the fuel line and flush the tank.
Check all of the fuel line connections for signs of leakage and check the
o-ring or gasket where the fuel lines connect to the pump.

Good luck ... Harold

  _____  

From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Bob
Spidell
Sent: Thursday, May 28, 2020 6:00 PM
To: healeys at autox.team.net
Subject: Re: [Healeys] Running problem

I had similar symptoms and an intermittent running poor condition on my BJ8.
After a lot of sleuthing I discovered that one of the vacuum piston needles
was loose and would drop into the jet hole, then get reattached and lifted
out down the road.  Wouldn't explain your large puddle of gas, though.

Bob

On 5/28/2020 4:50 PM, Brian Drab wrote:

About 4 years ago I rebuilt my HD8 carbs and the car has run great since
then with no adjustments required or made.

I put the car away for the winter in about November last year. 

In probably mid January I decided to take the car out. It was a gorgeous day
and I had to go to the grocery store about a mile away. I started the car
and it ran fine. I noted that the gas gauge read between empty and ¼ . I
started of to the store, but I noticed an obvious smell of raw gas when I
was driving. When I got to the store lot, I parked the car, did my shopping,
and came back out.  When I turned the key, I now noticed that the gas gauge
moved up to dead on empty whi8ch on my car means you are really out of gas!.
When I started the car, I got about 100 feet when the fuel pump started
hammering. I got another couple of feet and the car ran out of gas.
Fortunately, I was just across the street from a gas station so I took my
trusty gas can, went over and filled it,  then came back and poured it in
the gas tank. The car started up fine but began running really rough. I went
another ½ block into another store, parked the car and went  inside. When I
came back out about 15 minutes later there was a pool of gas, about
2-3’wide, under the front of the car. I started the car and it barely ran. I
literally had to coax it home. It sounded like severe fuel starvation –
running barely on about 3 cyclinders.

There was no more smell of raw gas nor any fuel leak as before.

When I got home, I rapped the top of the float bowls on each carb in caser
it was a stuck float valve. and it seemed to run a lot better. I felt at
that time that a float valve had stuck and probably siphoned the fuel out of
one of float bowls through the overflow tube.

Fast forward 3 months: 

Last night I was getting it ready to take it on a bit of a road trip today
it and when I took it out,  it ran very poorly – again like fuel starvation
but not as bad as before. It also popped back through the carbs frequently
which I interpreted  to be a very lean mixture 

I did the following:

put another 3 or 4 gallons of gas in the tank

Took the float bowls apart and cleaned them out – there was a bit of
sediment in them but nothing worthwhile. I also checked the floats which
were both leak free. I also cleaned out the float bowl filters at the in
line. 

I checked the Gros float valves and they seemed to work properly – held
upside down, they closed and opened right side up.

I disconnected the fuel line at the fuel pump and blew air back into the
tank thinking that when it ran out of gas, sediment in the bottom of the
tank may have plugged the intake. It blew fine into the tank. 

I have 2 fuel pumps on the car – the regular SU and a facet pump. I pulled
of the fuel line at the float bowl and turned on the ignition. The SU pump
and the facet pump each filled a coke bottle pretty  quickly. I did not
measure pressure. The gas looked clear and pure. I do not have a fuel line
filter. 

I checked the plugs all seemed good and were in fact burning on the lean
side. 

I pulled the distributor cap and it was nice and clean inside with no sign
of carbon tracks. 

I  have electronic ignition so there is nothing I can check there.

I checked the timing – it was right on. 

No matter what I did it didn’t make an improvement.

I replaced the Gros float valves but it made no difference.

Today I pulled the carbs (which on a BJ8 is no easy task) I checked  the
diaphrams and both were in good condition. 

Now I am stumped. Is it a fuel problem or something else? Can any one offer
any suggestions?

Brian Drab

Vancouver B.C.

_______________________________________________

Support Team.Net http://www.team.net/donate.html

Suggested annual donation  $12.75

Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive

Healeys at autox.team.net

http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/bspidell@comcast.net

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20200528/43010ce9/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Fuel Lines.pdf
Type: application/pdf
Size: 1794447 bytes
Desc: not available
URL: <http://autox.team.net/pipermail/healeys/attachments/20200528/43010ce9/attachment.pdf>