[Healeys] A-arm frame mounts specs

jim ab7vf at yahoo.com
Tue Feb 18 17:50:12 MST 2020


 if you are having to futz with the a arm frame attachment points (I did) be very aware of kingpin inclination angle ..determines castor/camber of wheel ..depending on frame/tweekage and replacement part tolerances, the backside of the mount is nowhere near any reference alignment point...if you gotta have it vertical for "pretty" grind the flange (where it welds to the frame)...AFTER verifying kingpin / axle / wheel caster-camber
Jim
"
    On Tuesday, February 18, 2020, 2:32:56 AM UTC, S and T Miller <stmiller96 at hotmail.com> wrote:  
 
  Anyone know the factory a-arm frame mount specs in degrees? One would assume 90 degrees when using a digital angle finder on the back side, but?

The Millers

"Always drive them, but remember each drive in an antique car is a test drive."
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75

Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/ab7vf@yahoo.com

  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20200219/5072f380/attachment.htm>


More information about the Healeys mailing list