[Healeys] gasket

Kees Oudesluijs coudesluijs at chello.nl
Fri May 24 06:31:38 MDT 2019


Give the washers a good soak for a few days in petrol/diesel and tighten 
up, get softer fibre washers from a plumber or use new soft 
copper/aluminium (with or without sealant) washers.

Kees Oudesluijs


Op 24-5-2019 om 13:44 schreef Don via Healeys:
> I’m working on a BJ-8 right now and I’m having a hard time stopping very slight fuel leaking out of the two banjo unions between the carbs . And I installed new fiber washers . Would it be ok to try some  gasket sealer on the fiber washers ?
>           Don       67 BJ-8
>
> Sent from my iPhone
>
>> On May 24, 2019, at 2:07 AM, John Spaur <jmsdarch at sbcglobal.net> wrote:
>>
>> Gasket sealer is almost always required when installing gaskets.
>>
>> John Spaur
>> San Jose, CA
>>
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>> Suggested annual donation  $12.75
>>
>> Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
>>
>> Healeys at autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
>>
>> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/fsufan1952@yahoo.com
>>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>


More information about the Healeys mailing list