[Healeys] wtb: oil line L-shaped bracket

[Al Fuller]

Bob - pictures of the line and bracket (with measurements) can be access at the link below. FWIW, this is from a friend's BJ-8...

https://www.dropbox.com/sh/cbuc0wj2ohp346x/AAAp_XrYpT4nHmO04fGVsLR2a?dl=0

I will leave the pictures there for a while, but will need to take them down to conserve space at some point, so if you need them, you should save them to your own machine...

Al Fuller



-----Original Message-----
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Bob Haskell
Sent: Wednesday, June 26, 2019 9:34 PM
To: Healey List <healeys at autox.team.net>
Subject: [Healeys] wtb: oil line L-shaped bracket

Listers,

I'm looking for the L-shaped bracket pictured in the attached photo.  It attaches to the firewall using one of the screws that holds the firewall insulation in place.  On the other end has a P-clip that holds the oil pressure gauge line.

The photo is from one of Moss' firewall insulation installation instructions.  The instructions have two photos that show the bracket, one for a BN7 MkII and one BJ8.

The bracket is not shown or listed in the factory parts manual I have. 
It looks like the P clip might be listed.  PCR0307 introduced at car 13751, which is the first tri-carb.

I've checked with a few of the usual suspects (BSC, Healey Surgeons, Kilmartin, AH Spares) and haven't had any luck.  Suggestions?

Looks like it would be easy enough to make, but would like to have one in hand to get the dimensions off of.

Cheers,

Bob Haskell
Austin Healey 3000 BN7/BT7 registrar