[Healeys] wtb: oil line L-shaped bracket

[i erbs]

I have one on my car. Would you like demensions and more photos?

Ira Erbs
Portland, OR
typos and artifacts are the fault of my phone

On Wed, Jun 26, 2019, 6:35 PM Bob Haskell <rchaskell at earthlink.net> wrote:

> Listers,
>
> I'm looking for the L-shaped bracket pictured in the attached photo.  It
> attaches to the firewall using one of the screws that holds the firewall
> insulation in place.  On the other end has a P-clip that holds the oil
> pressure gauge line.
>
> The photo is from one of Moss' firewall insulation installation
> instructions.  The instructions have two photos that show the bracket,
> one for a BN7 MkII and one BJ8.
>
> The bracket is not shown or listed in the factory parts manual I have.
> It looks like the P clip might be listed.  PCR0307 introduced at car
> 13751, which is the first tri-carb.
>
> I've checked with a few of the usual suspects (BSC, Healey Surgeons,
> Kilmartin, AH Spares) and haven't had any luck.  Suggestions?
>
> Looks like it would be easy enough to make, but would like to have one
> in hand to get the dimensions off of.
>
> Cheers,
>
> Bob Haskell
> Austin Healey 3000 BN7/BT7 registrar
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/eyera3000@gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20190626/c2be3546/attachment.html>