[Healeys] Horn Parts

[Kees Oudesluijs]

These are very easy to make up with thin carton or gasket material. Cut 
out the ring, inside as accurate as possible, outside plenty large 
enough. Press out two opposing screw holes using a ball bearing or 
similar. Insert two screw though the gasket to keep it in position and 
horn half and press out the remaining holes. Soak the gasket in oil for 
an hour  or apply sealer to both surfaces of the gasket and of the 
flanges of the horn an fit the halves together the way they were fitted 
before using screws and nuts or (pop)rivets. Trim the excess gasket 
material.

Kees oudesluijs



Op 15-6-2019 om 22:57 schreef Charles Schott:
> Does anyone know where I can get parts (gaskets) for rebuilding 100 
> horns? Thanks,
>
> Regards,
>
> Charlie
>
> ------------------------------------------------------------------------
>
>
>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys 
> http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/healeys/schottc@knology.net
>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20190616/b5e03067/attachment.html>