[Healeys] 100 front shroud "nose" measurements

[sentenac.rw at gmail.com]

A cross check would be to make sure that the rear contour of the apron
matches the contour of the lower front nose area.  It doesn't have to
be exact.  That's what the beading is there for :-)  But it should be
fairly close so that the bolt holes match up if you have some
originals to match to, and -with or without matching holes -  the
whole thing looks right.

If the shroud nose fits the apron, and the parking light half-holes
and the headlight half-holes in the shroud match the other half of the
holes in the fenders it will look right.

Been there and done that.

-Roland
BN1 #724, now on the road after 22 years
On Thu, 8 Aug 2019 09:00:59 -0400, you wrote:

>The most common measurement is 43-1/4”, so that’s a good starting point.  Car is 30+ miles away from me, so will be a few days before I can compare with its dimensions.  But the plumb line is a good suggestion—IF the shroud above the headlight isn’t distorted too!
>
>Sarah
>
>From: WILLIAM B LAWRENCE 
>Sent: Thursday, August 08, 2019 12:13 AM
>To: S. Carr ; Steven Kingsbury 
>Cc: Healey List 
>Subject: Re: [Healeys] 100 front shroud "nose" measurements
>
>Looks like the answers are all over the place. I think the real answer is that the seam where the front of the fender and the shroud meet may be the only straight line on the car. If you are sure the top of the shroud above the headlamp is true then just try dropping a line straight down from there and I think the dimension should be close.
>
>Bill Lawrence
>BN1 #554