[Healeys] clutch fork bushings

[Bob Spidell]

"does the taper pin drift out from trans side or clutch side?"

Yes.

But seriously--did this a couple years ago and dammed if I ever figured 
out for sure.  Both ends were peined over and I really couldn't tell 
even though I studied it for hours.  My best guess is, because the 
access hole is on the gearbox side, it was probably driven in from the 
clutch side (so you could drive it out from the gearbox side).  But 
don't quote me; IIRC I ended up drilling it out.

Bob

ps.  Bet David Nock knows ;)

pps.  I put a plastic plug in the access hole because, you know, dirt.


On 10/19/2018 2:15 PM, healeymanjim wrote:
> replacing clutch fork bushings and cannot remember.  does the taper pin drift out from trans side or clutch side?
> _______________________________________________
>
>