[Healeys] Fwd: Side shift trans covers

[i erbs]

Try to do 30 min a week on the car. After a while you will see progress and
be i spired to do more. Even if its just cleaning parts. It really helps.

Ira Erbs
Portland, OR
typos and artifacts are the fault of my phone

On Sat, Oct 13, 2018, 4:48 PM Tim Davis BN7 <tld6008 at mchsi.com> wrote:

> I have a center shift 3000 also but haven't got to the point of installing
> that part yet, at the rate I'm going it will probably be my grandson who
> does it.
>
>
> Tim Davis BN7
>
> ----- Original Message -----
> From: i erbs <eyera3000 at gmail.com>
> To: warthodson at aol.com
> Cc: Tim Davis BN7 <tld6008 at mchsi.com>, Ahealey help <
> healeys at autox.team.net>
> Sent: Sat, 13 Oct 2018 18:53:59 -0400 (EDT)
> Subject: Re: [Healeys] Fwd: Side shift trans covers
>
> Center shift covers fit in a channel, side shift do not. Making them a bit
> more if a challenge to get right
>
> Ira Erbs
> Portland, OR
> typos and artifacts are the fault of my phone
>
> On Sat, Oct 13, 2018, 2:20 PM <warthodson at aol.com> wrote:
>
>> I do not have a side shift transmission, but I would expect the hole in
>> the top of the tunnel to line up more closely. My center shift trans tunnel
>> lines up more closely.
>> I am sure that standard sheet metal screws (similar to wood screws) are
>> used to attach the tunnel flanges to the floor.
>> Do you have a copy of the Concourse guidelines & a copy of the factory
>> parts manual? They are a valuable resource for answering many detailed
>> questions.
>> Gary Hodson
>>
>>
>> -----Original Message-----
>>
>> From: Tim Davis BN7 <tld6008 at mchsi.com>
>>
>> To: Healey List <healeys at autox.team.net>
>>
>> Sent: Fri, Oct 12, 2018 1:44 pm
>>
>> Subject: [Healeys] Fwd: Side shift trans covers
>>
>> Trying again, since the original post I have rebuilt the rusted flanges
>> on both sections and they look new now. I have both uncarpeted sections set
>> in place but with the front bellhousing section in place, where it seems to
>> fit best, the hole for the shifter is not centered over the trans. See
>> attached. Will this positioning work ? I can't move the main cover to the
>> left much as it is over the drive shaft hump. Also does the front flange of
>> the trans cover screw  onto the bellhousing cover? I believe cupped trim
>> screws are used for the sides of the bellhsg cover but what is used for the
>> floor flanges, self tapping type? I have two snaps on each side of the man
>> cover for the carpet, is there one or two on the drvshaft tunnel?
>> I also posted this question awhile ago to another Healey forum (
>> https://www.ahexp.com/phorum/read.php?3,205482 ) worded a little
>> differently but have received no useful responses.
>>
>>
>>
>> Tim Davis BN7
>>
>> ----- Forwarded Message -----
>>
>> From: Tim Davis BN7 <tld6008 at mchsi.com>
>>
>> To: Healey List <healeys at autox.team.net>
>>
>> Sent: Tue, 31 Jul 2018 17:58:15 -0400 (EDT)
>>
>> Subject: Side shift trans covers
>>
>> I am about to install my two covers  after first test fitting for a
>> couple welding repairs. My front footwells are newly carpeted and the
>> forward section is lapping over the carpet on the sides, IS This correct?
>> When I try to fit that first piece alone where it would seem to be the
>> Main cover is too far forward i.e small gap at the drive shaft tunnel. So I
>> am thinking I need to get the big one in place regarding the tunnel and the
>> access holes which will be pulling the front section back where it doesn't
>> look like it would like to be ideally.
>> Does anyone have any photos of the two sheetmetal covers in place or
>> being installed/removed? Or any other words of wisdom?
>>
>>
>>
>> Tim Davis BN7
>>
>>
>>
>> _______________________________________________
>>
>> Support Team.Net http://www.team.net/donate.html
>>
>> Suggested annual donation $12.75
>>
>>
>> Archive: http://www.team.net/pipermail/healeys
>> http://autox.team.net/archive
>>
>> Healeys at autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
>>
>>
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/healeys/warthodson@aol.com
>>
>>
>> _______________________________________________
>>
>> Support Team.Net http://www.team.net/donate.html
>>
>> Suggested annual donation  $12.75
>>
>>
>> Archive: http://www.team.net/pipermail/healeys
>> http://autox.team.net/archive
>>
>> Healeys at autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
>>
>>
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/healeys/eyera3000@gmail.com
>>
>>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20181013/1549af75/attachment.html>