[Healeys] Break in oil

Patrick & Caroline Quinn p_cquinn at tpg.com.au
Sun Mar 4 19:34:59 MST 2018


I have just finished the running-in process (yesterday) with the BN3 using Penrite Running-In Oil.

Hoo Roo

Patrick Quinn
Blue Mountains, Australia

-----Original Message-----
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Bob Spidell
Sent: Monday, 5 March 2018 11:48 AM
To: healeys at autox.team.net
Subject: Re: [Healeys] Break in oil

My engine builder used Lucas 30W break-in oil.  They also pre-filled the block at the oil pressure line port.


On 3/4/2018 2:48 PM, David Masucci wrote:
> Hi all,
> Well I finally have my BJ8 engine almost ready to go back in the chassis. This rebuild includes minor mods including a Denis Welch DSW-8 cam and bucket followers (with pockets in the block) and high capacity oil pump. This cam is drilled to provide oil to each lobe. The engine was also balanced. Once broken in I plan to run 20W-50 Valvoline racing full synthetic with ZDDP, which I’ve run in my XJ6 since 2012 or so.
> Based on what’ve I’ve read, I should start and run the engine at 2000 RPM for 20 minutes or so. My question is what should I use for break in? There are so many types. Does anyone have a recommendation?
> Thanks as always.
> Dave
> 64 BJ8
> 72 XJ6

Support Team.Net http://www.team.net/donate.html Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys at autox.team.net

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/p_cquinn@tpg.com.au

More information about the Healeys mailing list