[Healeys] Rear Axle Hub Removal

[Per Schoerner]

Hi
I remembered wrong, I made it from a 55 mm hexagon socket.

Per

Skickat från min iPhone

> 6 sep. 2017 kl. 08:52 skrev Per Schoerner <per at schoerner.se>:
> 
> Mike
> Note that the nut is an octagon, would fit better on an MG. And one of them is threaded the other way around. I made my own socket from a very big hexagon socket (46mm IIRC) that I grinded to an octagon.
> 
> Per
> 
> Skickat från min iPhone
> 
>> 6 sep. 2017 kl. 00:01 skrev Michael MacLean <rrengineer.mike at att.net>:
>> 
>> OK, figured out how to get bearing hub off rear axle with a bearing flange and slide hammer.  Is the hub nut 2 3/16ths?  Is there a socket available without the chamfer around the mouth of the socket so I can get it on that thin nut?  Do you guys just buy a 2 3/16ths socket and grind the mouth flat?  The nuts on my axle are all buggered up from someone in the past using a chisel to get them off and put them back on.
>> Mike MacLean
>> 
>> 
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> 
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
> 
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/per@schoerner.se
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20170906/bb23b96b/attachment.html>