[Healeys] idle on BT7

[Oudesluys]

Lean mixture (easily rectified), worn crankshaft thrust bearing (check 
for for/aft movement of crankshaft), worn clutch bearing (not very likely).
Kees Oudesluijs

Op 11-10-2017 om 7:55 schreef healeymanjim:
> trying to adjust idle today on friend's BT7.  could get idle to pretty much hold 800-900 rpm but as soon as clutch is
> depressed the rpm would rapidly decrease about 500 rpm, then slowly drop until engine died.  this is a new one for me.
> have seen a couple hundred rpm drop but not where engine dies.  any ideas?
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
>