[Healeys] Stripped Water Pump Stud

Patrick & Caroline Quinn p_cquinn at tpg.com.au
Sat May 27 05:14:04 MDT 2017


G'day

 

Had a half hour to spare this afternoon so I thought I would fit the new
water pump to the BN3's six-cylinder engine.

 

Of the four nuts, three tightened without a problem. but I managed to strip
the thread the stud thread on the fourth.

 

Normally I would use the twin nut method, but with the stud stripped that's
not possible. So what to do? My 40+ year old vice-grips (mole-grips) can't
handle the strain and I don't have a welder to weld on a nut, nor do I have
an extractor.

 

Was thinking about filing the end of the stud flat on two sides and using a
crescent wrench or what we call a shifting spanner. Any experienced advice
out there?

 

Many thanks

 

Patrick Quinn

Blue Mountains, Australia

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20170527/9e4bdd9f/attachment.html>


More information about the Healeys mailing list