[Healeys] Trunk Seal

[warthodson at aol.com]

That is an interesting bit of trivia!
I have an aluminum boot lid, but would like to know where the cut ends on both the alum & steel lids.
Gary Hodson

Where the cut ends up depends if it is a steel or aluminium boot lid.


 
 
 
-----Original Message-----
From: josef-eckert <josef-eckert at t-online.de>
To: Michael MacLean <rrengineer.mike at att.net>; Healeys, Forum <Healeys at autox.team.net>
Sent: Tue, Jan 17, 2017 12:56 pm
Subject: Re: [Healeys] Trunk Seal



Mike it is the correct seal for a 100 and the sharp edge goes to the outside. Where the cut ends up depends if it is a steel or aluminium boot lid.

 
Josef Eckert
Königswinter/Germany
 
 
 
-----Original-Nachricht-----
Betreff: [Healeys] Trunk Seal
Datum: 2017-01-17T03:22:22+0100
Von: "Michael MacLean" <rrengineer.mike at att.net>
An: "Healeys Help" <healeys at autox.team.net>
 
 
 

Is this the correct cross section for the 100 trunk seal.  Of course it is a Moss item I bought a few years ago.  Just getting around to addressing the trunk area.  Which side goes towards the inside of the trunk?  All the way around in one piece? Where is the cut ends end up?
Mike MacLean
 


_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/warthodson@aol.com


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20170117/e9de2eb3/attachment.html>