[Healeys] BN4 lower grill lip

Andy Thorp bce257 at yahoo.co.nz
Tue Apr 19 21:06:37 MDT 2016

Hi Ira,

The repro finishers aren't so much like the original but they can be bent to fit and look kind of ok. The grille openings are also very varied so if you have one of the less-pretty grille openings then you'll have to cut the ends off the finisher to get it in.

There should be all ten grille bars showing and about 1/8 to 3/8 gap below the lowest bar. Cars leaving the factory often only had nine bars showing and the lads must have done some creative fitting to get them out of the door.

We can only aspire to be this perfect


Also beautiful

mmm nope

There was originally a peak in the middle of the finisher lip, repro's didn't worry about this little detail. Probably some factory trims didn't either.



Oh good god no

Ok so I may have OGD


On Wed, 20/4/16, i erbs <eyera3000 at gmail.com> wrote:

 Subject: [Healeys] BN4 lower grill lip
 To: "Ahealey help" <healeys at autox.team.net>
 Received: Wednesday, 20 April, 2016, 2:46 AM
 Good day.I am
 working on my grill. The replacement lower lip from Moss is
 not bent correctly. Any advice on getting it to fit
 correctly would be appreciated. Nearly 90 today in
 Portland,OR. Record heat. I rarther enjoyed my 72 degrees
 drives this last weekend.Cheers
 Ira ErbsPortland,OR      _______                      
      (______ \____1959 BN4____/
 BT7 engine and disk brakes
 Please excuse random auto corrects and misspelled

More information about the Healeys mailing list