[Healeys] Toe measurements on BJ8

[Bob Haskell]

Tom,

As Michael said, the car needs to be on the ground when checking 
alignment.  If the front suspension, in-board, lower, a-arm bushings 
were tightened up with the car jacked up, the tires won't sit flat.

Cheers,

Bob Haskell
AHCA 3000 Mk I registrar
http://www.ciahc.org/registry_3000mk1.php

On 10/19/2015 05:05 PM, Tom Felts wrote:
> Using the old stick method I tried to measure toe differences between the front and rear of the front tires----while car was jacked up.
>
> The rear ----measured same tread to same tread was a goof 1/2 to 5/8" wider than the front.  I believe there should be some positive difference between the two, but isn't this a bit much?
>
> I have been getting uneven wear---on the outside of the tires and was wondering if this might be the reason.
>
> Anyone have any thoughts you can share on this?
>
> thanks
> tom
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/rchaskell@earthlink.net
>
>