[Healeys] retorquing cylinder head nuts

[Oudesluys]

When re-torquing bolts/nuts I always break them loose by loosening them 
the smallest angle possible before I re-tighten them.
Kees Oudesluijs



Bob Haskell schreef op 16-5-2015 om 3:33:
> Listers,
> When retorquing cylinder head, should one loosen the nut being retorqued first? Not completely loose, but I would think that a nut could be under torqued, but would take more than the spec torque to break it loose.
>
> Cheers,
>
> Bob Haskell
> '60 AH3000 BT7 (big project)
> '62 AH3000 BT7 (smaller project)
> '64 Mini Cooper (small project - by definition)
> '68 BMW 1600 (first car - project)
> '80 MBG LE (running?)
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
>
>
> -----
> Geen virus gevonden in dit bericht.
> Gecontroleerd door AVG - www.avg.com
> Versie: 2015.0.5941 / Virusdatabase: 4342/9785 - datum van uitgifte: 05/15/15
>
>