[Healeys] Gauges and Morris
Steve Gerow
steveg at abrazosdata.com
Wed Jun 17 14:58:43 MDT 2015
A simple test setup, not requiring the MGA guru resistors and switch:
Remove sender from tank.
Use the battery or get a 12 volt power supply
Wires:
'T' terminal on gauge to post on sender (be very careful of this post so as
not to break the fine wire inside the sender)
'B' terminal on gauge to +12v
Gauge mounting screw to -12v
Sender flange to -12v
Move the sender arm back and forth to see the gauge moves smoothly from
empty to full.
--
Steve Gerow
Altadena, CA, USA
BN6 - 29D 3000 & 4 whl disc brakes
Check out my galleries:
http://www.pbase.com/stevegerow/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20150617/b38e741a/attachment.html>
More information about the Healeys
mailing list