[Healeys] Starter motor binding BT7
jmsdarch at sbcglobal.net
Mon Feb 23 11:36:11 MST 2015
I installed an additional thrust washer and the starter works fine now.
I am not sure if they original washers were sandwiched though; there is not
much room for a combination of washers that would be thick.
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Oudesluys
Sent: Sunday, February 22, 2015 1:15 AM
To: healeys at autox.team.net
Subject: Re: [Healeys] Starter motor binding BT7
There should be little play in the shaft so it is time to replace the thrust
washers. I am not 100% sure, but from memory I think it should be a
combination of 2 thinnish hardened steel washers and 1 thin fibre washer
sandwiched between the steel washers?
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Healeys