[Healeys] 100 carb balance pipe
cnaarndt at gmail.com
Fri Apr 24 12:08:17 MDT 2015
I believe (almost certain) that the 1/4" studs on the manifold are BSF on
BOTH ends. IF they were coarse threaded into the aluminum they would be
BSW, to match the BSF Whitworth threads on the other end.
On Thu, Apr 23, 2015 at 4:09 AM, Bob Haskell <rchaskell at earthlink.net>
> The threads are definitely BSF in these manifolds, but you're right -
> coarse thread is usually the case in aluminum.
> Bob Haskell
> AHCA 3000 Mk I registrar
> On 04/23/2015 06:21 AM, Alan Seigrist wrote:
>> Bob -
>> From memory I believe they have a section that isn't threaded in the
>> middle, with coarse thread to go in the manifold and fine thread for the
>> Then again I probably have no clue what I'm talking about.
>> On Thu, Apr 23, 2015 at 6:01 PM, Bob Haskell <rchaskell at earthlink.net
>> <mailto:rchaskell at earthlink.net>> wrote:
>> The balance pipe is attached to each intake manifold with two studs.
>> Are the studs just threaded rod, or is there a non-threaded section in
>> the middle? Assume that they're steel and overall length an inch.
>> Threads are 1/4-26 (BSF/BSC).
>> Bob Haskell
>> AHCA 3000 Mk I registrar
>> Support Team.Net http://www.team.net/donate.html
>> Suggested annual donation $12.75
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Healeys at autox.team.net <mailto:Healeys at autox.team.net>
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Healeys at autox.team.net
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Healeys