[Healeys] HS4 float chamber gaskets

Oudesluys coudesluijs at chello.nl
Tue Sep 23 02:30:21 MDT 2014


John,

New gaskets (and also used gaskets for that matter) should be soaked in 
oil (some prefer water) for a while before fitting. During the soaking 
they soften up and swell a bit and thus will mate better to the surfaces 
to be sealed.

Kees Oudesluijs
NL


John Spaur schreef op 22-9-2014 22:43:
> I noticed a little fuel around the lid of the float bowl where the gasket
> sits on two carbs. I replaced the gaskets with similar new black ones that
> are slightly oversized (the hang past the lid). They failed as if they were
> wicking gas from the bowl onto the bowl gasket mating surface. The fuel was
> not coming from the overflow or leaking at the lines. I made new gaskets and
> it solved the problem.
>
>   
>
> How can brand new gaskets fail like this? They were not damaged and the lid
> and bowl mating surfaces were not damaged either.
>
>   
>
> John Spaur
>
> '62 BT7
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
>
>
> -----
> Geen virus gevonden in dit bericht.
> Gecontroleerd door AVG - www.avg.com
> Versie: 2014.0.4765 / Virusdatabase: 4025/8257 - datum van uitgifte: 09/22/14


More information about the Healeys mailing list