[Healeys] Rear main seal

Wilko2 e-wilkins at cox.net
Fri Feb 21 15:54:13 MST 2014


The seal and mountings can be installed with the crank in situ. Mount plate is
two pieces and the seal is cut to allow fitting.


On Feb 21, 2014, at 2:47 PM, BJ8Healeys wrote:

>
> Well, one thing always leads to another.  As long as the clutch and
flywheel
> are off the car, why not replace the rear main seal?  It has 80,500 miles
on
> it, too.   But the rear main seal is a solid circle, like a typical wheel
> oil seal, and so is the housing that retains it at the back of the engine.
> I don't see any way to replace that seal without removing the flange first.
> Has anyone done this before?


More information about the Healeys mailing list