[Healeys] fuel gauge calibration

[BJ8Healeys]

The technique for calibrating a fuel gauge at the mgaguru site is good, but
be aware that the Healey fuel gauge is calibrated at a different maximum
resistance value (90 - 100 ohms) than the MGA gauge (68 ohms).

Also, be aware that if you loosen the adjusting nuts on the back of the
gauge too much and allow the guide foot at the bottom of each threaded post
(on the inside of the gauge where you can't see it) to come out of its slot,
you'll break the coil wire when you tighten the nut again and you'll be
sending the gauge off for professional repair.

Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC USA

-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of Bob Haskell
Sent: Thursday, November 07, 2013 6:05 AM
To: john spaur
Cc: healeys at autox.team.net
Subject: Re: [Healeys] fuel gauge calibration

John,

See the gauge/sending unit articles at 
http://mgaguru.com/mgtech/fuel/fuel.htm

Bob Haskell
AHCA 3000 Mk I registrar
http://www.ciahc.org/registry_3000mk1.php