[Healeys] OD solenoid adjustment

[Magnus Karlsson]

Gary,

First of all thanks for your kind comment about my video.

It can't be seen clearly but I do measure the lift on the ball in the
operating valve and the correct lift of the ball shall be 0,7 mm according to
the original workshop manual. I do not measure on the lever on the rigjt hand
side.

Magnus Karlsson
Sweden

Skickat frC%n min iPhone

23 mar 2013 kl. 21:08 skrev warthodson at aol.com:

> I was reviewing Magnus Karlsson's excellent overdrive videos & have a
question
> about measuring & setting the solenoid valve operating lever. It appears
that
> the dial indicator used to set the lever lift is measuring the 0.70 mm
(.028")
> lift on the end of the lever located on the RH side of the OD. My question
is
> this: Is this the correct place to measure the lift? I have read in other
> instructions that the lift should be measured by reading the lift of the
ball
> riding on top of the actual operating valve located inside the OD & the
> correct lift is .016". I do understand the lift of the external lever & the
> internal ball are directly related, so perhaps .028" at the lever is equal
to
> .016" at the ball. Any thoughts?
> Thanks,
> Gary
>
>
> -----Original Message-----
> From: john spaur jmsdarch at sbcglobal.net
>
> Check the videos at Magnus Karlsson website:
>
> http://healeyspecialists.com/
>
> John Spaur
> '62 BT7
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/magnuskarlsson@bornet.net