[Healeys] ring gear
Bob Spidell
bspidell at comcast.net
Wed Jan 16 19:02:07 MST 2013
Oh, and make sure the ring gear is oriented properly (the teeth are beveled on one edge).
On 1/16/2013 5:59 PM, Bob Spidell wrote:
> We did it with an oxy-acetylne torch. Heat the ring almost red hot and it'll fall off the flywheel (stand the flywheel
> on a cinder block). Set the new ring on a flat surface with the flywheel positioned squarely above it and heat the
> ring. 'Encourage' the flywheel and ring to mate up square.
>
> Bob
>
>
>
>
> On 1/16/2013 5:15 PM, Gbouff1 at aol.com wrote:
>> It's winter (in Connecticut), so I working on things that I can do in the
>> warmth of the basement. The ring gear on the flywheel of my 60 BN7 has
>> about 5 inched of teeth which look a bit ragged.
>> Has anyone out there changed their own ring rear? If so, what method did
>> you use to remove the old and replace the new ring gear.
>> Gary Bouffard
>> 60 BN7
>> _______________________________________________
>>
>>
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell at comcast.net
*******************************************************************
More information about the Healeys
mailing list