[Healeys] BJ8 Transmission Rebuild

Jonas Payne jagmog at hotmail.com
Wed Jan 2 09:06:33 MST 2013


To those that answered - thanks - yes there are in fact two relieved teeth
on the mainshaft approximately 90 degrees apart that should correspond with
the plunger locations on the hub.  This condition is pretty typical on lots
of transmissions, it wasn't noted in my manual so I absolutely wasn't
looking for it.  

I would have hoped that I'd have enough common sense to look for it after
handling the plungers in the 1st place.



Jonas Payne
PBR Consulting
702-882-6711

-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of Per Schoerner
Sent: Monday, December 31, 2012 4:02 PM
To: healeys at autox.team.net
Subject: Re: [Healeys] BJ8 Transmission Rebuild

Jonas, Michael
The BJ8 gearbox I have on the bench right now have two plungers in the 3/4th
hub. This is a very late (1967) BJ8 though. If you have disassembled the
hub, you have to be very observant when assembling it again, there is only
ONE way that the parts fit together.

Per

Michael Salter skrev 2012-12-31 18:59:
>> From memory the 3/4th hub on the BJ8 box is different from the 
>> earlier ones
> in that it has an extra plunger which must be aligned correctly with 
> the 3rd motion shaft groove..
$12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/jagmog@hotmail.com


More information about the Healeys mailing list