[Healeys] Thread Chasing

[Oudesluys]

Try a thread file and go easy about it, bit by bit.
Kees Oudesluijs

Mike Tobin schreef op 15-12-2013 21:56:
> The threads on the crank and cam ends are munged up.  The previous
> re-builder and his damn cold chisel.
> The crank nut will just get started but the cam nut won't even do that. I
> bought new nuts and it didn't get any better. I can see the bad spots, but
> I don't have a die or thread chaser near big enough for these and I don't
> want to force them for fear of just making things worse.
> Do I have to buy dies for this?  If so what size.
> Other suggestions?
> Thanks,
> Mike Tobin
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
>
>
> -----
> Geen virus gevonden in dit bericht.
> Gecontroleerd door AVG - www.avg.com
> Versie: 2014.0.4259 / Virusdatabase: 3658/6922 - datum van uitgifte: 12/15/13