[Healeys] BJ8 Carbs -- Install together or separately?

[Alan Seigrist]

Greg -

Unfortunately the BJ8 carbs must go on and off as a pair because of the
throttle cross shaft slots into the throttle levers on the carb shafts.

I have found that using the shortie box wrench (from craftsman pro) is the
best way to get to those nuts under the rear carb.

http://www.craftsman.com/craftsman-professional-11-pc-standard-full-polish-12/p-00944138000P?vName=Hand+Tools&cName=Wrenches&sName=Combination+Wrench+Sets&prdNo=1&blockNo=1&blockType=L1

Best,

Alan


On Tue, Nov 27, 2012 at 6:47 AM, Greg Mandas <gmandas at yahoo.com> wrote:

> Do "You" remove/install the carbs on a BJ8 together as one unit or
> separately?
>
> I do them together, but it's a bit difficult to get to the two bolts under
> the rear carb.
>
> I'm assuming to replace them separately, you'd have to disassemble the
> linkage and reset it afterwards.
>
> Greg
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/healey.nut@gmail.com