[Healeys] bending exhaust down pipes

[John Rowe]

David
You seal one end by welding plate- pack very tightly with dry sand, the seal
other end the same way. Then with oxy/acetylene torch heat till red and bend
away
Good luck
Cheers
John Rowe  Qld Australia
BN1 BT7

-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of David Lodge
Sent: Monday, 12 November 2012 4:07 PM
To: Jackson Krall
Cc: healeys at autox.team.net
Subject: Re: [Healeys] bending exhaust down pipes

Not sure if the pipe has to be heated or not.  I'll give it a pop one of
these
days!D

--- On Mon, 12/11/12, Jackson Krall <jackson_krall at yahoo.com> wrote:

From: Jackson Krall <jackson_krall at yahoo.com>
Subject: Re: [Healeys] bending exhaust down pipes
To: emmgeeteecee at yahoo.co.uk
Cc: healeys at autox.team.net
Date: Monday, 12 November, 2012, 6:02


David
Ive been aware of the sand technique for a long time and have always wanted
to
try it. I read somewhere that its the way the "bundle of snakes" header on
Jim
Clarks 65 Indy Lotus Ford was fabricated.
Best
JK


------------------------------