[Healeys] clutch alignment tool

[Oudesluys]

If you have an old input shaft, that is the best tool you can get. It is 
what I use. If you have a wood lathe, you can make one up from an old 
broomstick. If all fails there are many sets (cheap to expensive) 
available with a variety on diameters to match the spigot bearing and 
the hole in the clutch plate.
Kees Oudesluijs
NL



Op 1-11-2012 0:15, sdesalvo at frontiernet.net schreef:
> I need a clutch alignment tool for my '55 BN1. Any idea where I might find one?
> Thanks in advance,
> Sam