[Healeys] BN1/2 Boot Floor Holes

I Erbs eyera3 at gmail.com
Fri Jun 17 19:05:48 MDT 2011


My BT7 had about 20 holes drilled into the boot floor by the dpo. I figured
he could not locate z boot lid seal so he drained the water out of it.....

Ira Erbs
IT Consultant
Portland, OR

sent from my Droid, please excuse typos and random self corrections because
my phone has It's own ideas about what word I meant to write

On Jun 17, 2011 1:56 PM, "Bob Spidell" <bspidell at comcast.net> wrote:
> In all the excitement over the two low-mileage 100s I noticed something:
both cars had small--I'd guess 5/16" dia--holes on either side of the boot
pan floor. These holes were about equidistant--i.e., about a third of the
way in from the sides--on the squarish, raised portion of the boot
floor--the pressed-in, 'embossed' part of the panel-- in front of the gas
tank strap T-bolt holes .
>
> Anyone know what these holes are for? The obvious guess is drainage, but
they're on a raised (I think--maybe not) portion of the boot floor so
wouldn't be useful for that and, IIRC, there are no pins, studs, etc. on the
gas tank that would require relief.
>
> I don't think my original BJ8 boot floor had them, nor did the Kilmartin
replacement for our BN2 or the Moss 'std' part I put in my BJ8 (and that,
folks, is why I pay close attention to 'original' cars).
>
> TIA,
> Bob
>
> --------------------------------
> Bob Spidell - San Jose, CA
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/eyera3@gmail.com


More information about the Healeys mailing list