[Healeys] Boot pan to shroud

[Curt/Nancy Arndt]

Listers,

If I can't see it, then I can't judge it, and I DON'T care.

Cheers,

Curt Arndt
Chairman-AH Concours Committee

On Thu, Oct 14, 2010 at 11:59 PM, Jaap Aeckerlin <j.aeckerlin at gmail.com>wrote:

Bob, you have to realise that electrolytic corrosion only takes place when
> the relative humidity at the joint is over 50%. Any permanent elastic mass
> between the two mating flanges will ensure no moist will be present, hence
> no corrosion. Paint and/or tape will still leave a crevice where moisture
> can be present.



> *(Most probably the Concours guys will not approve this solution).*
>


> Jack Aeckerlin, The Netherlands
> 1964 BJ8 29432
>
> 2010/10/15 Bob Spidell <bspidell at comcast.net>
>
> >  Listers,
> >
> > I'm replacing the floor pan in the boot of my BJ8.  What do y'all
> recommend
> > to seal and insulate the steel lip of the pan against the aluminum lip of
> > the rear shrould?  I'm considering:
> >
> > 1) couple coats of paint on each
> > 2) a layer or two of electrical or silicone tape
> > 3) #1 and #2
> > 4) other?
> >
> > TIA,
> > Bob
> >
> > --
> > *******************************************************************
> > Bob Spidell           San Jose, CA            bspidell at comcast.net
> >
> > *******************************************************************
> > _______________________________________________
> > Healeys at autox.team.net
> > Donate: http://www.team.net/donate.html
> > Suggested annual donation  $12.75
> > Archive: http://www.team.net/archive
> > Forums: http://www.team.net/forums
> > Unsubscribe/Manage:
> > http://autox.team.net/mailman/options/healeys/j.aeckerlin@gmail.com
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage <http://www.team.net/forums%0AUnsubscribe/Manage>:
> http://autox.team.net/mailman/options/healeys/cnaarndt@gmail.com