[Healeys] Front Bumper Brackets

[Rich C]

Hi Mark,

The front bumper brackets on your 6 cylinder Healey will have (when viewed 
straight down from above) the straight brackets on the inboard side until 
they come to the bumper mounting bosses, where they turn roughly 90 degrees 
inboard. The angled brackets come straight out just so far and then do a 
single outboard angle 'till it gets out to the bumper, then a single angle 
outboard so it can lie flat against the bumper mounting bosses. There should 
be no curving of the brackets in any way, again, when viewed looking 
straight down from above.

Rich Chrysler

--------------------------------------------------
From: "Mark LaPierre" <lapierrem at sbcglobal.net>
Sent: Thursday, June 10, 2010 10:46 PM
To: <healeys at Autox.Team.Net>
Subject: [Healeys] Front Bumper Brackets

> Which way do the front bumper brackets go?  The brackets are 2 flat steel 
> bars
> welded
> together.   One bar is straighter than the other.   Does the straighter 
> bar go
> to the inside or
> outside of the car?
>
> The holes are not lining up either way for me right now so I will have to
> enlarge the bracket holes
> but I would at least like to get them lined up on the right side to start
> with.
>
> Thanks Guys,  Mark
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/healeys/richchrysler@quickclic.net