[Healeys] PCV valve- from Pep Boys

[John Sims]

If you guys go ahead and make that installation, please shoot me a photo to
include in the article. I just added a photo of the installation for a two
carb BN6 and I am going out the door in a few minutes to buy a PCV valve to
install later today on my BN6 and I'll add that photo also.

John Sims, BN6
Aberdeen, NJ
 
http://www.healey6.com


-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of Bob Spidell
Sent: Wednesday, July 28, 2010 12:04 PM
To: Stephen Hutchings
Cc: healeys at autox.team.net
Subject: Re: [Healeys] PCV valve- from Pep Boys

Use the smaller tapped and plugged hole at the rear of the manifold.

bs

--------------------------------
Bob Spidell - San Jose, CA

----- Original Message -----
From: "Stephen Hutchings" <s.hutchings at rogers.com>
To: healeys at autox.team.net
Sent: Wednesday, July 28, 2010 8:35:52 AM
Subject: Re: [Healeys] PCV valve- from Pep Boys

I've looked at the photos of the PCV installation on John's website, which
are helpful, but what do you do when the manifold hole is already occupied
by the brake servo, as on a BJ8?

Stephen, BJ8