[Healeys] King Pin with needle bearings

[Stephen Hutchings]

OK, since we're getting into specifics; I've got most of the 
components, including the roller bearings, together, but I won't be 
putting them on the car until it's warmer. I've been wondering about 
the shimming procedure for this, because I haven't done it before.
Is it like the front wheel bearing job(which I have done a couple of 
times)  where you remove shims until you get the right end float 
within a torque range? If so, what is the torque setting, because the 
manual doesn't say.
To put it simply, when do you stop turning the nut, and assess the end float?

Stephen, BJ8