[Healeys] Chuck Key--No Healey content

[bighealey3k at aim.com]

Yea, you didn't mention it was frozen.  Is it threaded on or a taper fit?  If
it is threaded on, you can chuck up a large allen wrench at the short end ("L"
shaped) by hand and strike the long end of the allen wrench with a hammer in
the loosening direction to hopefully unscrew it.  Hope that helps.

Larry Wendland
'67 BJ8 (original owner)



-----Original Message-----
From: awgertoo at aol.com
To: bighealey3k at aim.com
Cc: healeys at autox.team.net
Sent: Sun, Jan 3, 2010 3:22 pm
Subject: Re: [Healeys] Chuck Key--No Healey content



In a message dated 1/3/2010 3:19:13 P.M. Eastern Standard Time,
bighealey3k at aim.com writes:
Take the chuck off of the drill press


Did I forget to say that the chuck is frozen and cannot be removed?

Best--Michael