[Healeys] front tube shock conversion
Roland Wilhelmy
rwil at sbcglobal.net
Mon Feb 22 22:50:28 MST 2010
I must have been lucky, then. It's been several years since I installed Udo's kit on our BJ7 but I don't recall anything more complicated than the usual fiddle in bolting stuff up on tall screws. Alan, were you defeated in your efforts to install Bilsteins in front?
-Roland
----- Original Message ----
> From: Alan Seigrist <healey.nut at gmail.com>
> To: richard mayor <mayorrichard at hotmail.com>
> Cc: healeys <healeys at autox.team.net>
> Sent: Mon, February 22, 2010 8:02:28 PM
> Subject: Re: [Healeys] front tube shock conversion
>
> Udo's kit is different both front and back. His back kit is a bolt on
> replacement, actually a fairly decent set up.
>
> The front kit is good too but can be quite tough to install as it
> requires perfectly parallel alignment of the rear bolt holes, which
> given the way the captive nuts are welded to the top plate.
>
> Alan
More information about the Healeys
mailing list