[Healeys] overdrive throttle switch rebuild

[Bob Spidell]

John,

You probably got no replies because no one has tried this.  If there's 
no set screw, it's probably--there's that word again--an interference 
fit.  Frankly, I doubt you can get it off and back on without messing 
something up--I think you'd have to clamp the shaft in a vice and 
somehow pry the cam off, but you'd probably mess up the case.

bs



john spaur wrote:
> This is a repeat of my post last week; no responses so I am trying again.
>
> I want to zinc plate the housing.
>
> How is the cam removed from the shaft, is it a press fit, can it be 
> removed fairly easily; if so how?
>
> TIA
> John Spaur
> '62 BT7
> _______________________________________________
>
>


-- 
*******************************************************************
Bob Spidell           San Jose, CA            bspidell at comcast.net

*******************************************************************