[Healeys] temp sender wrench

[Freese, Ken]

One should check which wrench they want to sacrifice before doing the deed.
The swing is pretty limited as I recall. One might need a C type curved
wrench.
Ken Freese
65 BJ8

-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of Bob Spidell
Sent: Tuesday, August 10, 2010 2:55 PM
To: Don Day
Cc: healeys at autox.team.net
Subject: Re: [Healeys] carb oil

Or buy a cheap 5/8" socket and cut a slot in it with a cutoff tool.

bs

--------------------------------
Bob Spidell - San Jose, CA


I bought a quart of 30wt,they didn't have 20wt,I will bring it back,then look
for a place that sells 20wt.In the mean time I used 3 at 1.I am ready to start
the motor up,I put anti-freeze in and I found that I didn't tighten up the
temperature sending probe that goes into the block.5/8 craws foot needed.I
wonder if they sell a 5/8 oxygen sensor socket?That would work.
_______________________________________________
Healeys at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/kendall.freese@aerojet.com