[Healeys] Brass float repair

[David Nock]

drill a small hole in the float to get all the gas out of the float.  
Then solder the hole up that you drilled in the float. Then submerge  
the float in hot water You will see small bubbles coming out of the  
float where it is leaking. Make a note of those locations and then  
solder up those leaks. Repeat in the hot water until you have no  
bubbles.


David Nock
British Car Specialists
Stockton Ca
209-948-8767
www.britishcarspecialis.com

On Oct 9, 2009, at 7:35 PM, edic wrote:

> I have a small pin hole in one of my brass carb floats and need  
> some guidance
> on a repair, a step by step explanation would be helpful.
>
>
>
> Mel Brunet
>
> HBJ8L/39749
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healeydoc at verizon.net
>
> http://www.team.net/archive